Your shopping cart is empty!
- sales@diyglass.com.au
- CALL: 0414 266 624
Guided Ordering
- DIY Glass Balustrades
- Deck Mount Glass Balustrade
- Deck Mount Glass Balustrade Using Spigots
- Deck Mount Glass Balustrade Using Posts
- Deck Mount Glass Balustrade Using Channel
- Face Mount Glass Balustrade
- Deck Mount Glass Balustrade
- DIY Glass Pool Fencing
- DIY Glass Shower Screens
- DIY Glass Splashbacks
Direct Ordering
Search Product
Splashback Installation Pins
When installing a glass splashback for each hole in the glass you will need:
1 x Pin Cap
1 x Thread Rod
If installing onto a timber stud, you will use a Lag Screw to Metric Thread rod and for masonary you will need to use a Threaded Rod installed using a chemical anchor.
1 x Pin Cap
1 x Thread Rod
If installing onto a timber stud, you will use a Lag Screw to Metric Thread rod and for masonary you will need to use a Threaded Rod installed using a chemical anchor.
115mm Lag Screw to Metric Thread
- M12 Heavy Duty Screw
- 115mm overall length
- Allows installation into timber or composite material
- Suits all standoffs
- Hex drive allen head.
M12 x 120mm Threaded Rod
- M12 Heavy Duty
- 120mm overall length
- Allows installation into concrete by using a chemical anchor
- Allows installation through steel using an M12 nut or tapped thread
- Suits all standoffs
38mm Diameter Flat Splashback Pin Cap
- 316 Grade Stainless Steel
- M12 thread in the back
- 12mm Thick with Bevelled Cap Finish
- 1mm Thick Washer Included
You will also need to order the correct installation rod
- Installation into Timber will require a Lag Screw to Metric Threaded Rod
- Installation into Masonry will require a Threaded Rod
- Phone: 04142 66 624
(Monday to Friday, 9am to 4pm AEST) - Email: This email address is being protected from spambots. You need JavaScript enabled to view it.