0 item:
 x 

Your shopping cart is empty!

Guided Ordering

Direct Ordering

Search Product

Face Mount using
Standoffs with Top Mount Rail

Step 4. You're Almost There

Now comes the fun part of choosing your handrail profile and doing the calculations for the glass panels required.

If you haven't already done so now would be a good time to take some measurements and do a layout drawing. It is important to indicate any existing posts, walls, steps as these will all influence your requirements.

You will first need to do the calculations for the panel sizes. Once you have determined these you will need to calculate the number of standoffs required based in the number of pre-drilled holes in the glass panels. You will also need to calcuate the lengths of top rail tube and fittings you require.

You will need to go through the below 3 pages and add your items to your shopping cart.

1280mm High Glass Panels

We have over 20 standard size glass panels available that are 1280mm high and range in width from 700mm to 1800mm that have been pre-drilled with holes for standoff installation with an offset top rail. These panels are suitable for use with friction spigots, channel, glass clamp and slotted tube posts.

Click Here

Top Mount Rails

There are 5 different profiles of top mount handrails that can be used. Each profile has a slot along the bottom that sits over the glass.

Profiles available:

Click Here

Balustrade Requirements Calculator


Please enter in your details below.

You will need to break your dimensions down into sections. The sections can be in between posts, corners or where you need to finish at the end of a glass panel.

Please enter your balustrade details section by section you will need to enter the total length in mm as well as what the rail starts and end on for each area.
1 Choose your requirements.
Max Panel Size
Desired Gap
Minimise Handrail Joins: Yes    No
2 Choose your style. (You can change these at any time)
Spigots:
Top Rail:
Rails & Fittings Finish
3 Choose your fence lengths. (You can change these at any time)
Section 1 Length (mm):
Starts on:
Ends on:
Add a row
Remove a row
 
Click calculate to see your results.
Your section lengths and choices are saved.

Calculation Result:

Material Finish:

Confirm Your Project

After you are happy that you have entered in all details about your sections correctly you can add the above calculated items to your shopping cart to proceed with your order.
You can empty your cart at any stage, your calculations will not be lost.
   

Joomla SEF URLs by Artio
  • Phone: 04142 66 624
    (Monday to Friday, 9am to 4pm AEST)
  • Email: This email address is being protected from spambots. You need JavaScript enabled to view it.