0 item:
 x 

Your shopping cart is empty!

Search Product

Guided Ordering

Direct Ordering

Splashback Installation Pins

When installing a glass splashback for each hole in the glass you will need:
1 x Pin Cap
1 x Thread Rod

If installing onto a timber stud, you will use a Lag Screw to Metric Thread rod and for masonary you will need to use a Threaded Rod installed using a chemical anchor.
Results 1 - 4 of 4

115mm Lag Screw to Metric Thread

$7.60
  • M12 Heavy Duty Screw
  • 115mm overall length
  • Allows installation into timber or composite material
  • Suits all standoffs
  • Hex drive allen head.

M12 x 120mm Threaded Rod

$3.00
  • M12 Heavy Duty
  • 120mm overall length
  • Allows installation into concrete by using a chemical anchor
  • Allows installation through steel using an M12 nut or tapped thread
  • Suits all standoffs

Standoff Tool

$15.30
  • Tighten and loosen 38mm and 50mm diameter standoffs
  • Made from 316 Stainless Steel

38mm Diameter Flat Splashback Pin Cap

$7.10
  • 316 Grade Stainless Steel
  • M12 thread in the back
  • 12mm Thick with Bevelled Cap Finish
  • 1mm Thick Washer Included

You will also need to order the correct installation rod

Finish
Finish of Product
  • Phone: 0414266624
  • Email: This email address is being protected from spambots. You need JavaScript enabled to view it.